The float switch through at least two complete cycles.
Tethered float switch adjustment.
Efore tightening adjust tether length.
Adjust float up or down.
Rod settings are made by sliding the sump float up and down the desired.
The pump is then idle until the water level rises again.
The float controls an on off switch for the pump.
Step by step disconnect from power.
When the float rises to a pre set height the pump will be switched on.
The pump will continue to operate until the float drops low enough to disengage the switch.
Next manually or electronically adjust the float switch up or down based on the water level in.
Manual adjustment manual adjustments are made on either a rod or a tether depending upon the model of sump pump you own.
Anytime you are working on your sump pump it should be disconnected from the power.
Make sure the pump operates at the desired levels.
Tether length.
Test with bucket of water.
Attach the float switch to the top of the pump.